Скачать драйвер для Onkyo TX-NR838 AV Receiver Firmware 1050-4110-0001-0300-0001

Fixes:

- Applies minor bug fixes

Precautions for TX-NR838 Firmware Update:

- The firmware update should take 30 to 40 minutes. Once the update begins, don't turn off the power supply to the A/V receiver until it is time to restart it
- Depending on the conditions of the network, a firmware update via a network may take more than one hour or even fail to finish. If the update is not completed within two hours, turn off the power supply by pushing the ON/STANDBY button and then try updating again from the beginning
- Updating the firmware and adjusting the settings will be done automatically, but may take some time to complete
- If your A/V receiver is damaged for any of the reasons above, an Onkyo service center will repair the unit for a fee

Note that the update may fail, or cause problems for your A/V receiver, if you do any of the following:

- Pull out the A/V receiver's power cord
- Interrupt the power supply to the A/V receiver (e.g. if the breaker is tripped or if there is an electrical outage)
- Insert or remove the LAN cable from a device in your network when updating over a network
- Insert or remove a USB memory device from the A/V receiver when updating via USB
- Operate components connected to the A/V receiver via HDMI, such as a TV or a recording device

Примечание: Ссылка "скачать" может вести как непосредственно на файл, так и на сайт производителя, на котором Вы можете найти нужный файл.
Это связано с тем, что некоторые производители не позволяют размещать прямые ссылки на файлы.