Скачать драйвер для NETGEAR GSM712F Switch Firmware 2.4.1

Fixes:
- Fixed some corner cases for port-based VLAN application.
- Fixed crash caused by nmap task.
- Fixed a page-misalign problem in the Multicast page in the Web.
- Fixed a bug, which caused telnet to fail sometimes.
- Limited the length of an URL to 255 characters in the Web server.

Enhancements:
- Add IEEE 802.1w (Rapid Spanning Tree Protocol) support. The default mode for STP changed from IEEE 802.1d to IEEE 802.1w.
- Add support for EAP-TLS and EAP-TTLS for 802.1x Port Authentication.
- Add support for RADIUS accounting.
- Add support to allow range of IP address in host IP filter table or SNMP host table.
- Change the firmware upgrade procedure in Net-Save mode that the firmware will be downloaded and saved to the on-board Flash before the switch is rebooted. This solved the problem of upgrade failure when using fiber GBIC.
- Add a new control in SNMP access to allow read access to any host.
- Change SNMP read access from blocked to allowed by all hosts as default.


It is highly recommended to always use the most recent driver version available.

Do not forget to check with our site as often as possible in order to stay updated on the latest drivers, software and games.

Try to set a system restore point before installing a device driver. This will help if you installed a wrong driver. Problems can arise when your hardware device is too old or not supported any longer.

Примечание: Ссылка "скачать" может вести как непосредственно на файл, так и на сайт производителя, на котором Вы можете найти нужный файл.
Это связано с тем, что некоторые производители не позволяют размещать прямые ссылки на файлы.