Скачать драйвер для NETGEAR XSM7224S Switch Firmware 9.0.1.14

Fixes:
- Support license key activation
- Support RIPv1/v2(license needed)
- Support OSPFv2(license needed)
- Support IGMP(license needed)
- Support PIM-SM,PIM-DM(license needed)
- Support DVMRP(license needed)
- Support IPv6 unicast routing(license needed)
- Support OSPFv3(license needed)
- Support IPv6 PIM-SM,PIM-DM(license needed)
- Support MLD(license needed)
- Support priority based flow control (IEEE 802.1Qbb ) on standalone XSM7224S (not supported on stacked XSM7224S, or standalone XSM7224S which have stacked ports configured)
- Support NSF(RFC 3623, No Stop Forwarding) for OSPFv2/v3 Graceful Restart(license needed)
- A Cisco SFP+ direct attach cable is not link up on XSM.
- XSM7224S task always run very busy.
- Fail to download image to slave by HTTP.
- Image name changed from “master/active” in 9.0.0 to “image1/image2” in 9.0.1
- Default SNTP client port is 0.
- Disable ICMP redirect as default in 9.0.1.
- Configured network management IP lost after issuing 'no ip address dhcp' on a routing port.
- LAG interface counter shows Jumbo frame transmitted as transmit errors.


It is highly recommended to always use the most recent driver version available.

Do not forget to check with our site as often as possible in order to stay updated on the latest drivers, software and games.

Try to set a system restore point before installing a device driver. This will help if you installed a wrong driver. Problems can arise when your hardware device is too old or not supported any longer.

Примечание: Ссылка "скачать" может вести как непосредственно на файл, так и на сайт производителя, на котором Вы можете найти нужный файл.
Это связано с тем, что некоторые производители не позволяют размещать прямые ссылки на файлы.