Скачать драйвер для NETGEAR JGSM7224 Switch Firmware 9.2.0.7

Fixes:
- Cannot access JGSM7224 through SNMPv3 if user privilege is set to read-only.
- Unable to clear DHCP L2 Relay Statistic counters from Web GUI.
- Unable to set CoS and IP precedence value to 1 or 4 when configuring Differv policy action via Web GUI.
- DHCP snooping trust mode of Port-channel 8 gets enabled automatically after a static MAC address binding is added to port 1 on the "Static Binding Configuration" table under Security > Control > DHCP Snooping > Binding Configuration page.
- Refreshing or clearing DHCP Snooping Statistics counters will cause the Web GUI session to end automatically.
- Unable to clear DHCP L2 Relay Remote ID string through Web GUI.


It is highly recommended to always use the most recent driver version available.

Do not forget to check with our site as often as possible in order to stay updated on the latest drivers, software and games.

Try to set a system restore point before installing a device driver. This will help if you installed a wrong driver. Problems can arise when your hardware device is too old or not supported any longer.

Примечание: Ссылка "скачать" может вести как непосредственно на файл, так и на сайт производителя, на котором Вы можете найти нужный файл.
Это связано с тем, что некоторые производители не позволяют размещать прямые ссылки на файлы.