Скачать драйвер для Netgear FVX538v1 Firmware 2.1.2-7

Before upgrading, write down all the configuration information you changed from the defaults. You may need to reenter them later. These typically include password, security settings and ISP configuration.

NOTE: The router will reset itself to factory defaults after upgrading to version 2.x.
Version 1.x and 2.x configurations are not compatible and cannot be used across software versions.

Bug Fixes:

* Incorrect EST time with extra info
* Changing password does not log out user. Now changing admin username/password closes the
existing session with message "Admin Settings changed successfully, Please re login using new username/password" and goes to login page.
* Router Statistics: does not have DMZ info
* CLI command for deleting(monitor/diag/arpDel) an arp entry and listing (monitor/diag/arpShow) is added
* Support for login timeout in CLI and Telnet. Change in Idle time will not take affect in any opened/existed CLI session. Changes will only take affect when changing the time from a new CLI sessions.
* WebGUI enhancements for WAN settings: WebGUI second row: only WAN setting and LAN setting.
WAN mode goes to third row. LAN setup, LAN groups, and Multi-home LAN IP setup goes to third row. The Multi-home LAN IP setup is too hidden.
* Once secondary IP addresses are full, they cannot be modified.
* Options to turn on/off ICMP echo reply (Ping reply) and ICMP timestamp reply on both LAN and WAN interfaces. Disable Ping Reply on LAN Ports and Disable DNS Proxy are added in"LAN Security Checks". By default Ping reply on LAN port and DNS Proxy is allowed.
* SA lifetime mismatch between FVX538 and other Netgear products like FVG318 causes tunnel to drop. Now upon expiry of ISAKMP SA, sends a delete payload to peer.
* Guest account can see the Preshared keys in plain text in the IKE policy. Now guest user can't see the PSK in edit ike policy and view selected IKE policy in VPN policies page.
* Loss of HTTP management and VPN access Cannot edit custom services even when service is disabled
* NetMeeting does not work
* Traffic meter does not support more than 9999MB
* Web component blocking is not saved
* Diagnostic ping to WAN address in router mode uses LAN IP as source IP. Added a check box in diagnostic ping and user should select when pinging through VPN tunnel (which will internally use LAN IP as source ip so that ping packet can hit SP)and when check box is not selected WAN IP will be used as source ip.
* Allow HTTPS for local administration
* Added Telnet management to WAN port. Default is off.
* Error when click "reset" button on keyword blocking web page.
* Inbound firewall rule port translation does not work.
* Inbound firewall rule works intermittently.
* “current IP address” wraps to two lines



It is highly recommended to always use the most recent driver version available.
Do not forget to check with our site as often as possible in order to stay updated on the latest drivers, software and games.

Try to set a system restore point before installing a device driver. This will help if you installed a wrong driver. Problems can arise when your hardware device is too old or not supported any longer.

Примечание: Ссылка "скачать" может вести как непосредственно на файл, так и на сайт производителя, на котором Вы можете найти нужный файл.
Это связано с тем, что некоторые производители не позволяют размещать прямые ссылки на файлы.