Fixes: - Add Netgear public SNTP server as default - Add warning message during upgrade via CLI - Dot1x: MAC based authentication doesn’t work - SNTP:‘SNTP server time-f.netgear.com’ will cause ‘script apply’ command to failed - SNTP: additional character for command 'clock timezone' - STP: path external-cost changed while modifying path cost - "show port status all" output always show STP mode of port channel group as Blocked. - If SNTP server reply with "Server Kiss of Death" message, the SNTP client in the switch will stop - LAG stop fowarding traffic after running a period of time when GVRP is enabled - MTU value shown via SNMP is wrong - DHCP server error message is cryptic - ezconfig does not prompt for default route/gateway - Console port might hang while executing "show hosts" - Wrong client identifier shown in the DHCP show pool configuration page - The Interface names in error message when a port is added to a LAG group which it is already a member of, are wrong - SNTP: the same SNTP server IP address or name can be added twice. - DNS fails to work - GSM7312 does not detect SFP port problem when TX side failed but RX is working - Traffic destined to VMAC stop forwarding after rebooting VRRP master - Updating firmware or config file via XODEM protocol does not work over serial port - DNS error message is crypted - Switch will not pass IS-IS packets
Скачать