Versions: - BIOS : 02.02.0002 - ME : 02.01.07.328 - BMC : 01.20.5446 - FRUSDR : 1.12 Changes in BIOS 02.02.0002: - Fixed: The system can't power up after restoring the BIOS default value via removing the CMOS battery Changes in ME 2.01.07.328: - Fixed: Platform is not able to power on properly after being shut down by NM Policy - Fixed: Global platform power consumption reported by NM Statistics in S5 is incorrect - Fixed: OOB (out-of-band) stress test by issuing the wrong username may cause connection to be unavailable - Fixed: Shutdown action can be interrupted by cold reset when volatile NM policy is in use Changes in BMC 01.20.5446: - Fixed: The Embedded Web Console was showing the incorrect version of ME Firmware when the ME was in firmware update mode. - Fixed: Nothing displayed on the Embedded Web Console while logging in with an IPv6 address (stateless ICMPv6 discovery). - Fixed: BMC Embedded Web Console session not maintained with a power cycle - Fixed: System does not maintain BMC web console session during power state change or system reset. - Fixed: The Intel Xeon Phi Coprocessor adapters numbering is not consistent with riser slot numbering on server board. - Fixed: Embedded Web Console SEL text log not decoding BIOS update versions correctly. - Fixed: No video display in BMC KVM when SUT wakes up from S1 or S3 in Windows* 2012. - Fixed: S2600IP - Intel Xeon Phi Coprocessor adapter MIC Status 7 shows as Unknown in some configurations. - Fixed: S2600GZ - Intel Xeon Phi Coprocessor adapter MIC Status Sensor shows "Unknown" when only 1 MIC card exists in system. - Fixed: Cannot set link-local gateway for BMC Network Management Interface using IPv6. - Fixed: [X] Web Console not defaulting to English when another non-English browser is detected. - Fixed: Add Cross Frame Options to prevent cross-frame scripting of Embedded Web Console - Fixed: Browser autocomplete enabled before authentication. - Fixed: SMI Timeout errors not logging IIO Global error registers in Debug Log - Fixed: BMC LAN connection not working after IP address change. - Fixed: Multi-node boards with node ID 1111 are not regarded as a single node. - Fixed: BMC email alerts refused by some servers. - Fixed: IP address of baseboard management NIC can't be configured successfully when dynamic and static IP changed. - Fixed: The baseboard management NIC can't get a dynamic IP address when the VLAN set as enable. - Fixed: Change to 1600W PSU firmware for an acoustic issue. - Fixed: POST Error code 0xA6A0 was causing the SEL page to fail to render. - Also fixes decode of POST Error code 0x0012 and invalid POST Errors causing the SEL page to fail to render. - Fixed: The ME firmware has 2 minor versions in the update related SEL. - Updated the OEM command format to support this. - Added: Support Intel Xeon Phi Coprocessor adapters in Intel Server Boards and Systems. - Added: Added a button on Web to enable/disable IPMI over LAN. Changes in FRUSDR 1.12: - Added FRU file for S2600GL and Updated Master.cfg This download is valid for the products listed below: - Intel Server Board S2600GL - Intel Server Board S2600GZ - Intel Server System R1000GL Family - Intel Server System R1000GZ Family - Intel Server System R2000GL Family - Intel Server System R2000GZ Family
Скачать