Скачать драйвер для Yamaha QL1 Digital Mixer Firmware 1.07

New Features:
- Now supports the Help function.

Improvements:
- When you initialize the unit, the initial setting of the WORD CLOCK is now changed to DANTE 48k in order to be synchronized to the same clock between devices in the system where multiple CL/QL units are used even with the initial settings.
- When you initialize the unit including the Dante audio network setting or updated the firmware, the initial setting of "Preferred Master" is now changed to ON.
- When you change to the output channels from the input channels in the bank select key, the SEND field of the SELECTED CHANNEL VIEW screen will change to the MATRIX tab from the MIX tab. Then, MIX tab is now displayed when you return to the input channel.
- A pink frame is now shown around the SEND knob in the SELECTED CHANNEL VIEW screen that you can operate by using the [TOUCH AND TURN] knob in the conjunction to press the MIX/ MATRIX bus key in the SENDS ON FADER section.
- In the Initialized state, the STEREO channel L/R are now assigned to the OUTPUT PATCH window of the I/O device.
- Now supports Ro8-D SYNC, SYSTEM indicators.

Fixed Bugs:
- In the QL firmware V1.07, you can remotely control the internal HA of a QL series by using the Port to Port function, from additional QL series or CL series (firmware V2.03 or later) consoles.
- Solved a problem in which "With Recall" could not be enabled on external consoles, when QL's internal HA settings were recalled by the scene on the QL itself.
- Solved a problem in which the corresponding HA settings on the remote QL would not correctly recall, when you recalled an Input Channel Library.
- Solved a problem in which the function of Rio’s HA REMOTE did not work correctly if you changed the DANTE PATCH from an external device when you turned OFF the MIXER SETUP of the USER LEVEL.
- Solved a problem in which the DIRECT PLAY of RECODER allocated to the USER DEFINED key or the CH OPERATION in the USER LEVEL page was not set correctly, when you were logged in as a guest.
- Solved a problem in which the changing link parameters in the link group might be applied in another group.
- Solved a problem in which the set value of the gain was not pasted correctly, when you executed the paste operation where the Gain Compensation was changed from ON to OFF in the Global paste.

Known issues:
- If the Dante Virtual Soundcard (DVS) is patched to the QL series device using Dante Controller, the patching may not be recalled correctly when the QL series device is restarted. Patch DVS again. In addition, when using a version of DVS for Windows that is older than v3.2.0, the patch after CH41 cannot be performed from QL series consoles.
- If the setup of REDUNDANT/DAISY CHAIN is changed while the Dante device is not connected with Dante PRIMARY/SECONDARY connectors, no audio signal will pass. Audio will once again pass after the Dante device is connected or after the power for the QL series device has been restarted.


It is highly recommended to always use the most recent driver version available.

Do not forget to check with our site as often as possible in order to stay updated on the latest drivers, software and games.

Try to set a system restore point before installing a device driver. This will help if you installed a wrong driver. Problems can arise when your hardware device is too old or not supported any longer.

Примечание: Ссылка "скачать" может вести как непосредственно на файл, так и на сайт производителя, на котором Вы можете найти нужный файл.
Это связано с тем, что некоторые производители не позволяют размещать прямые ссылки на файлы.