Скачать драйвер для Yamaha QL1 Digital Mixer Firmware 1.02

Improvements:
- In the QL firmware V1.01, a message was displayed to restart after initialization. This is no longer required. However, in the case of initializing the Dante Setup, be sure to disconnect all Dante devices before initialization.

Fixed Bugs:
- Fixed a problem in which the CL series device rarely freezes when you record or play back files with the USB memory recorder, after performing specified operations on the console.
- Solved a problem in which the DANTE PATCH would not be reflected when you reconnected the "VIRTUAL" I/O device, which was previously set up but did not exist on the network for some time.
- Solved a problem in which the IN indicator would not light in the INSERT field on the SELECTED CHANNEL VIEW screen.
- Solved a problem in which the key-in meters for MIX OUT 13-16 would not work on the KEY IN SOURCE SELECT window of the dynamics.
- Solved a problem in which the patching would not be reflected, if you loaded (or synchronized from QL Editor) a setting file in which an empty premium rack was mounted.

Known issues:
- If the Dante Virtual Soundcard (DVS) is patched to the QL series device using Dante Controller, the patching may not be recalled correctly when the QL series device is restarted. Patch DVS again. In addition, when using a version of DVS for Windows that is older than v3.2.0, the patch after CH41 cannot be performed from QL series consoles.
- If the setup of REDUNDANT/DAISY CHAIN is changed while the Dante device is not connected with Dante PRIMARY/SECONDARY connectors, no audio signal will pass. Audio will once again pass after the Dante device is connected or after the power for the QL series device has been restarted.
- In some specific network switching conditions, a QL series device may link at 100Mbps instead of the expected 1Gbps. This could be due to the self-checking function of some switches. Use the Device Status screen of Dante Controller to check the link speed of each device. If it shows up as 10 or 100, then disconnect the network cable for this device and re-connect it to correct the problem. To avoid the problem in most cases, first allow the network switches to fully boot up before turning the power on for the QL series devices.

Important Notice:
- Please do not use the EEE function of network switches in a Dante network.
- You need to update the Dante-MY16-AUD firmware to V3.3.9 or later before using the Dante-MY16-AUD with the QL series.
- Dante Firmware Update Manager v1.4.5.7 does not support Mac OS X 10.6.8.


It is highly recommended to always use the most recent driver version available.

Do not forget to check with our site as often as possible in order to stay updated on the latest drivers, software and games.

Try to set a system restore point before installing a device driver. This will help if you installed a wrong driver. Problems can arise when your hardware device is too old or not supported any longer.

Примечание: Ссылка "скачать" может вести как непосредственно на файл, так и на сайт производителя, на котором Вы можете найти нужный файл.
Это связано с тем, что некоторые производители не позволяют размещать прямые ссылки на файлы.