Скачать драйвер для Nikon COOLPIX P500 Firmware 1.1 for Mac OS

Fixes:
- When a fully charged battery was inserted in the camera, the camera used and then turned off and left for a while, in some rare cases the battery was exhausted and the camera could not be turned on again. This issue has been resolved.
- In some rare cases, the monitor failed to properly display images with continuous shooting at a setting of Continuous L. This issue has been resolved.
- When the following SD memory cards were inserted into the camera and the camera turned on, the “This card cannot be used.” message was sometimes displayed. This issue has been resolved.
SanDisk Extreme Pro SDHC UHS-I (32 GB, 16 GB, 8 GB)
SanDisk Extreme SDHC UHS-I (32 GB, 16 GB, 8 GB, 4 GB)
SanDisk Extreme Pro SDHC UHS-I (32 GB, 16 GB, 8 GB)
SanDisk Extreme SDHC UHS-I (32 GB, 16 GB, 8 GB, 4 GB)
- An issue that caused settings registered using the Save user settings option to be reset when camera settings were reset using the Reset all option in the setup menu with [U] (user setting) shooting mode enabled has been resolved.


It is highly recommended to always use the most recent driver version available.

Do not forget to check with our site as often as possible in order to stay updated on the latest drivers, software and games.

Try to set a system restore point before installing a device driver. This will help if you installed a wrong driver. Problems can arise when your hardware device is too old or not supported any longer.

Примечание: Ссылка "скачать" может вести как непосредственно на файл, так и на сайт производителя, на котором Вы можете найти нужный файл.
Это связано с тем, что некоторые производители не позволяют размещать прямые ссылки на файлы.