Скачать драйвер для NETGEAR JWNR2000v1 Router Firmware 1.0.0.9

Fixes:
- Added pre-set SSID and Passphrase feature.
- Added WPS 2.0 feature.
- DynDNS: only supports www.DynDNS.org.
- Take off "Trust IP Address" in QoS.
- Take off Traffic Meter, and Guest Network feature.
- Fixed igmp proxy bugs: igmpv3 didn't ignore upstream member report.
- Modified to send broadcast ACK if received DHCP Request had BROADCAST flag. To fixed Netger WNCE2001 and WNCE3001 DHCP failure issue.
- Refine PPP behavior for RU BT issue: do LCP echo reply in kernel space to avoid echo reply time out problem in heavy traffic.
- Enable wpa security in wds mode (only for PR)
- Refine QoS bandwidth detection algorithm to make it mush more accurate.
- To avoid some abnormal PPPoE sever in China, we limit sending PADT to only 2 times.
- Add RU ISP collect-info feature.
- Changed to use new algorithm for uplink bandwidth detection.

Note:
- Do not upgrade the firmware using a wireless connection. Please perform firmware upgrade with “wired” or Ethernet connection only.
- The upgrade process is completed when the on screen progress bar completes. If power LED light turns amber and blinking, power cycle the router to complete the upgrade.


It is highly recommended to always use the most recent driver version available.

Do not forget to check with our site as often as possible in order to stay updated on the latest drivers, software and games.

Try to set a system restore point before installing a device driver. This will help if you installed a wrong driver. Problems can arise when your hardware device is too old or not supported any longer.

Примечание: Ссылка "скачать" может вести как непосредственно на файл, так и на сайт производителя, на котором Вы можете найти нужный файл.
Это связано с тем, что некоторые производители не позволяют размещать прямые ссылки на файлы.