Скачать драйвер для NETGEAR GSM7324 Switch Firmware 6.2.0.14

Fixes:
- Add support for new POE switch FSM7328PS
- Add “save” command allows saving running config into flash with a single command
- Add “show running config interface” shows the configuration per interface
- Configure certain IGMP snooping using Web GUI, the switch might crash
- FSM7300S: Unable to bind MAC ACL list to the interface
- FSM7300S: IP ACL does not work properly
- FSM7300S: “show interface” command right after the switch is rebooted will cause the crash
- SNMP v3 packet might cause the switch to crash
- GSM7312 crashes when the client address is blank in SNMP Community config
- SNTP Server Configuration pageAddress Type" field is mistakenly configured as "DNS", device fails to update the time
- VLAN GUI config page is error in not highlighting the member
- GSM7328FS: fiber SFP link not up after module remove and reinsert
- GSM7300S/FS - master unit reboot intermittently
- GSM7300S/FS: eventlog shows corrupted entry
- FSM7326P: IGMP Snooping: 'ip igmpsnooping unknown-multicast filter' does not take effect
- When device originates ARP request for the target in secondary network with Sender IP Address as Primary Interface
- When using default IP address in network interface, copy command failed
- MFDB table do not get updated when client send IGMP leave
- The speed for the port for 1G SFP module is shown to be unknown when specific port is selected on port configuration web page
- Fails to accept host name begins with digit (0-9).
- GUI : garbage character appear when configuring policy map
- Dot1x : access fail after changing port-control from auto to force-authorized
- Port security may impede MAC address learning
- GSM7328S crashed when combo port mode is set to speed of 100Mbps
- GSM7328S could not set 100Mbps half-duplex for gigabit port
- GSM7328S port status stayed down when both sides port mode are set at 1000Mbps full-duplex.


It is highly recommended to always use the most recent driver version available.

Do not forget to check with our site as often as possible in order to stay updated on the latest drivers, software and games.

Try to set a system restore point before installing a device driver. This will help if you installed a wrong driver. Problems can arise when your hardware device is too old or not supported any longer.

Примечание: Ссылка "скачать" может вести как непосредственно на файл, так и на сайт производителя, на котором Вы можете найти нужный файл.
Это связано с тем, что некоторые производители не позволяют размещать прямые ссылки на файлы.