Скачать драйвер для Cisco WRVS4400Nv2 Router Firmware 2.0.1.3

Fixes:
- Fixed an issue that caused the RIP packet size to grow larger over time.
- Fixed an issue that caused a duplicate “default route” entry to show up in the routing table.
- Fixed a session logout issue by enabling a Log Out button.
- Fixed an issue that caused the router to become unresponsive and unrecoverable after the reset button during a firmware upgrade.
- Fixed an issue in the SIP-ALG code that caused a blind call transfer from one IP Phone to another IP Phone to fail.
- Fixed both of the QuickVPN user name and password fields to support a character length of up to 32 characters maximum.
- Fixed an issue that caused some printers to be unable to print over an IPSec VPN tunnel between two physical locations.
- Fixed an issue that caused the TrendMicro ProtectLink Gateway feature to fail to filter URLs if a customer accessed the URL through search results when the approved URL list had any URL entered.
- Fixed an issue that caused IPv6 packets between different VLAN’s to not be blocked if inter-VLAN routing is disabled.
- Fixed an issue that caused a QuickVPN tunnel to not be re-established when more than “any” remote gateway is configured for the tunnel settings.
- Fixed an issue that caused port forwarding rules to stop if IPS was disabled.
- Fixed an issue that caused the DDNS status to always show “Please Wait” in the web-based management interface of the router.
- Fixed an issue that caused WDS to not allow more than one access point to connect to the WRVS4400N for wireless repeater support.
- Converted the style of the ProtectLink Gateway administration page to the style of the current ProtectLink Web administration page.
- Fixed an issue found in the Time Zone setting that caused the system time to be incorrect when the Time Zone is set to “(GMT-03:30) Newfoundland.”
- Fixed an issue in the SIP-ALG code that caused certain SIP packets to be tagged with the incorrect VLAN ID.
- Fixed an issue with WDS that caused the router wireless driver to be unresponsive when trying to get a WAP4410N access point to associate to WRVS4400N.
- Fixed an issue in the VPN code that caused the QuickVPN client to drop the connection when the QuickVPN client connects to the QuickVPN server behind a NAT router


It is highly recommended to always use the most recent driver version available.

Do not forget to check with our site as often as possible in order to stay updated on the latest drivers, software and games.

Try to set a system restore point before installing a device driver. This will help if you installed a wrong driver. Problems can arise when your hardware device is too old or not supported any longer.

Примечание: Ссылка "скачать" может вести как непосредственно на файл, так и на сайт производителя, на котором Вы можете найти нужный файл.
Это связано с тем, что некоторые производители не позволяют размещать прямые ссылки на файлы.